Graco ISPA109AC Uživatelský manuál stáhnout pdf (Strana 61)

• Combination Lap/Shoulder

Belt with Sliding Latch Plate

This belt has a latchplate that

slides freely along the belt.

This belt MUST be converted to prevent

movement of the lap portion of the belt. You

must use the locking clip provided with the

infant restraint, unless your vehicle's seat belt

can be converted in another way as described

in your vehicle owner's manual.

To Install Locking Clip:

1. Tighten the buckled belt by pushing

down hard on the infant restraint and

pulling hard on the shoulder belt.

2. While pushing down on infant restraint,

pinch the two straps together behind

the buckle tongue. Unbuckle the

belt without allowing it to slip.

3. Connect lap and shoulder belts

with locking clip as shown



and .

4. Rebuckle belt. Check that lap

belt does not move by pulling

and pushing hard on infant

restraint. If belt loosens or

lengthens, repeat procedure.

Locking clip

inch



Locking clip goes here,

/2 inch from the buckle



1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 124 125

Žádné komentáře

Models	Document Type
HDM-3200W	User Manual Protec General Catalog 2013 ver.1-3, 44 pages User Manual catalog - Nipros, 64 pages Operations Instructions protech HDM-3200W Operating instructions, 40 pages Service Manual protech HDM-3200W Technical data, 108 pages User Manual スライド 1 - NIPROS \| by SYSTEC International, 29 pages User Manual NIPROS 2014 Catalogue (Print), 20 pages
HDM-4000	Operations Instructions protech HDM-4000 Operating instructions [en] , 36 pages
HDM-900WD	Service Manual protech HDM-900WD Service manual, 74 pages User Manual Nipros General Catalog 2013 ver.1-3, 44 pages Operations Instructions protech HDM-900WD Operating instructions, 46 pages

Graco ISPA109AC Uživatelský manuál Strana 61