Graco 309643B Uživatelský manuál

Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441Copyright 2002, Graco Inc. is registered to I.S. EN ISO 9001InstructionsStainless Steel Air Motor C

Installation 10 309643BReassembly of Fluid Covers1. Inspect the wrench flats on the shaft (24) for burrs that could damage the air motor seals (402).

Installation309643B 11

All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves th

Installation 2 309643BInstallationPressure Relief Procedure1. Shut off the air to the pump2. Open the dispensing valve, if used3. Open the fluid drain

Installation309643B 3Metal Fluid Section PumpsDisassembly of Inlet and Outlet Manifolds1. Relieve the pressure, see page 2. Disconnect all hoses.2. Re

Installation 4 309643BDisassembly of Fluid Covers1. Remove the screws (106) holding the fluid covers (101) to the air covers (23). Pull the fluid cove

Installation309643B 5.FIG. 3105Cutaway View, with Diaphragms in PlaceCutaway View, with Diaphragms Removed12Lips face out of housing (1).Rounded side

Installation 6 309643BReassembly of Fluid Covers1. Install the diaphragm assembly on one end of the shaft as follows:a. Install new o-ring (108), prov

Installation309643B 7Plastic Fluid Section PumpsDisassembly of Inlet and Outlet Manifolds1. Relieve the pressure, page 2. Disconnect all hoses.2. Remo

Installation 8 309643BDisassembly of Fluid Covers1. Remove the screws (106) and (112) holding the fluid covers (101) to the air covers (23). Pull the

Installation309643B 9FIG. 610524033401310422441612Lips face out of housing (1).Rounded side faces diaphragm (401).3Air Side must face center housing (